Conversion To Another Type Of Gas; Commissioning; Troubleshooting - Modular FCG 051 Serie Manuel D'installation, D'emploi Et D'entretien

Do not tamper with appliance components.
Appliance maintenance and conversion to a
different type of gas must be carried out by qualified
technicians authorized by the manufacturer, in
compliance with current safety standards and the
instructions in this manual.
17. CONVERSION TO ANOTHER TYPE OF
GAS
See Chapter " Instructions for installation ".

18. COMMISSIONING

See Chapter " Instructions for installation ".

19. TROUBLESHOOTING

LABEL CAUSE
MALFUNCTION
Er1 CHAMBER
TEMP. PROBE
MALFUNCTION
ER2
CORE PROBE
CORRECTIVE
MESSAGE
MEASURE
Block of
the
cooking
cycle in
Replace the
progress.
chamber
The buzzer
temperature
beeps for
probe
five
seconds
every
twenty.
Block of
the
cooking
cycle only
if there is
in progress
a core
Replace the
probe
core probe
cooking
phase. The
buzzer
beeps for
five secods
every
twenty.
d-r DOOR OPEN
ALL GAS CHAMBER
THERMAL
Alt
ALARM
ELECTRONIC
ErL BOARD
CONNECTION
OVEN
THE OVEN DOES NOT START
Check that the multiple pole switch is closed and
-
there is mains voltage.
Check that the gas shut-off cock upstream of the
-
appliance is open.
- Check integrity of the oven protection fuses.
- Ensure the oven door is correctly closed.
Check to have correctly set the cooking cycle
-
parameters.
- Ascertain the oven is not in error.
THE FAN STOPS DURING FUNCTIONING.
Switch-off the oven and wait for the motor thermal
-
protection to automatically reset.
- Ensure that the cooling inlets are not obstructed.
WATER DOES NOT FLOW INTO THE HUMIDIFIER
TUBES.
- Check that the water shut-off cock is open.
31
Deactivati
on of the
exits. The
cycle is not
blocked
Close the door
and
restarts
when the
door is
closed.
Block of
the cycle Check the gas
in system
progress.
Press the red
Block of
button on the
the cycle
safety
in
thermostat
progress.
body.
Washing Check
interruptio electronic
n board