Modular FCG 051 Serie Manuel D'installation, D'emploi Et D'entretien page 26

Once plugged in, the oven is in "stand-by" condition,
it shows the label "OFF"
The oven control panel is equipped with a knob "M"
to perform the insertion and modification of the
functioning parameters of the appliance.
Such knob can also be pressed to select a function or
confirm a certain parameter.
The knob acts on a digital encoder and, therefore, is
in continuous rotation. The parameters adjusted by
the encoder vary clockwise increasingly.
Cooking temperatures range from a minimum
temperature of 0° to 280° C.
I tempi di cottura impostabili variano da infinito a
240min.
By default the oven set the fan speed to maximum.
HUMIDIFIER
You can set the percentage of humidity in the
chamber
during a cooking cycle.
the value can be set at the beginning of the cycle or
during the execution of the cycle.
- Press button T9;
- Turn knob M to the value to be set;
- Press the knob to confirm the value.
HUMIDITY DRAINIG VALVE
The humidity draining valve has the task of expelling
humidity formed inside the cooking chamber during
the cooking.
Even with the valve closed, there is no risk of
overpressures inside cooking compartment as
because over-pressure is controlled by the drain.
At the end of the cooking cycle the valve remains in
the position it was in at that moment.
The opening or closing of the humidity discharge
valve is controlled by pressing the T8 key.
The valve opening is signalled by the led L3
- Led on: VALVE OPEN
- Led off: VALVE CLOSE
FANS
Pressing the T12 you can change the fan speed
The default speed is set to high,LED 6 on. Pressing
the T12 switching from high to low speed, L7 on
COOLING
At the end of a cooking cycle the oven has the
possibility to set a cooling cycle to lower the
temperature inside the baking chamber
When the oven is in stand-by mode, proceed as
follows:
- Press button T5;
- Press the T13 button to start.
The oven starts to cool by spraying water on the
- moving fan (oven door closed) or just using the fan
(oven door open).
The cooling cycle is terminated when the
-
temperature of the cooking chamber reaches 50 ° C.
CONVECTION COOKING
Once turned on the oven by pressing button T1, D3
display shows the label "ON".
Select convection cooking mode by pressing the T2
button.
D3 display shows the label "CNV"
Display D1 will alternately flash the LED L1 and L2.
Set the cooking chamber temperature pressing T6
button (default 200 ° C). The cooking temperature
may vary from 50 to 280 ° C.
To change the temperature, turn the "M" knob to
the desired temperature. To confirm the value press
the "M" knob.
Display D2 shows the label "t", confirm by pressing
"M".
By default, the cycle time is set to "infinity", turn the
knob "M" until the desired cooking time and press
"M" to confirm.
Display D2 shows the value 0, concerning humidity
required for cooking. Set the required value turning
the "M" and confirm.
D2 display shows the label "CLS" related to the drain
valve.
The setting parameters of the drain valve are three:
CLOSE (CLS)
OPEN (OPN)
PRE-OPENING (PRE)
The pre-opening of the drain valve allows to set how
long before the end of the cooking cycle the valve
will open.
Set the desired value by turning the knob "M" and
confirm.
The D3 display shows the label "H" concerning the
fan speed set by default on high. Turn "M" knob to
change the value from High to Low and confirm.
26