Unpacking; Intended Use; Assembling The Support Rod - IKA RET Control-Visc Mode D'emploi

• Unpacking

- Unpack the device carefully
- Any damage should be notified immediately to the shipping
agent (post office, railway network or transport company)
• Scope of delivery
- RET control-visc heated magnetic stirrer
- Power supply cable
- Operating instructions
- Screwdriver (safety circuit)
- USB cable
• Use
- The magnetic stirrer is suitable for mixing and / or heating
substances.
• Area of use
Indoor environments similar to that a laboratory of research,
teaching, trade or industry area.
• Review the mounting and safety instructions of the IKA boss
head clamp prior to using it. (see "Accessories")
• The device must not be suspended from the support rod!
22
Unpacking

Intended use

Assembling the support rod

17 mm
4.
4.
3.
2.
3. 2.
1.
1.
- Protective cover: H 104
- Magnetic stirring bar: IKAFLON 30 and 40 mm
- Temperature sensor: PT 100.70
- O Ring
O-Ring
Please slide the O-Ring on the power cord plug to avoid ingress of
water into the connector.
The safety of the user cannot be guaranteed:
- if the device is operated with accessories that are not supplied
or recommended by the manufacturer,
- if the device is operated improperly or contrary to the
manufacture's specifications,
- if the device or the printed circuit board are modified by third
parties.
Note:
When using bath attachments with a diameter over 180 mm, use
support rod in conjunction with an
extension (see "Accessories").
DANGER
Risk of tipping!
Make sure that the center of mass
of the attached device does not
protrude over the safe area indicat-
ed below with a dotted rectangle.
safe area