Description Of The Unit; Operation; Handling - Daikin LBB Série Manuel D'installation

3

Description of the unit

LBB (Outdoor Unit)
1
4

Operation

5

Handling

WARNING
Make sure that no one is in transit in the operating area of the lifting/transport means to
prevent any possible accidents to people.
If the unit is in a wooden case or crate, sling the packing properly before handling it.
Lifting speed shall be such as not to make the packed unit oscillate dangerously and
possibly fall.
The LBB-LBC series includes air-cooled or water-cooled (optional) condensing units
built in split version. They consist of:
1. a condensing unit placed outside the cold room;
2. an evaporator installed inside the cold room;
3. an electric control panel placed on the condensing unit, complete with wall-
mounted remote control panel;
LBB-LBC single blocks are compression units where cold is produced by vaporizing a
liquid refrigerant (HFC type) at low pressure in a heat exchanger (evaporator). The
resulting vapour is brought again into the liquid state by mechanical compression at a
higher pressure, followed by cooling in another heat exchanger (condenser).
The compressor is hermetic, with reciprocating motion, supplied with single-phase or
three-phase power.
Defrost takes place automatically in pre-set cycles, by injecting hot gas ( standard);
manual defrost is also possible.
The unit can be handled by lifting and transport means.
3
3
LBC (Indoor Unit)
2
18