To Remove The Accessories From The Outdoor Unit; Preparation; Preparing The Installation Site; Installation Site Requirements Of The Outdoor Unit - Daikin RXP20M5V1B Manuel D'installation

3 Preparation

1
2
2.1.2 To remove the accessories from the
outdoor unit
1 Lift the outdoor unit.
2 Remove the accessories at the bottom of the package.
a b c d
1× 1× 1× 1×
a General safety precautions
b Outdoor unit installation manual
c Fluorinated greenhouse gases label
d Multilingual fluorinated greenhouse gases label
e Drain plug (located on the bottom of the packing case)
Installation manual
4
e
1×
3 Preparation
3.1

Preparing the installation site

WARNING
The appliance shall be stored in a room without
continuously operating ignition sources (example: open
flames, an operating gas appliance or an operating electric
heater).
3.1.1 Installation site requirements of the
outdoor unit
Mind the following spacing guidelines:
>150 >300
b
a
(mm)
a Air outlet
b Air inlet
It is recommended to install a baffle plate when the air outlet is
exposed to wind.
It is recommended to install the outdoor unit with the air inlet facing
the wall and NOT directly exposed to the wind.
b
a Baffle plate
b Prevailing wind direction
c Air outlet
3.1.2 Additional installation site requirements
of the outdoor unit in cold climates
Protect the outdoor unit against direct snowfall and take care that the
outdoor unit is NEVER snowed up.
b >150
a
>50
(mm)
b
a
(A)RXP20~35M5V1B
R32 split series
3P519299-5B – 2018.12