Care And Cleaning; Cleaning The Filters - Zanussi ZDT16002 Notice D'utilisation

• The display shows 2 horizontal status bars.
• The indicators of the programme buttons come on.
When you cancel a delay start, the appliance goes
back to setting mode. You have to set the pro-
gramme again.
Cancelling the programme
Press and hold function buttons (B B ) and (C C ) at the same
time until:
• The display shows 2 horizontal status bars.
• The indicators of the programme buttons come on.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
At the end of the programme
When the programme is completed, an intermittent acous-
tic signal operates.
1. Open the appliance door.
• The display shows 0 0 .

Care and cleaning

Warning!
Before maintenance, deactivate the appliance and discon-
nect the mains plug from the mains socket.
Dirty filters and clogged spray arms decrease the
washing results.
Make a check regularly and, if necessary, clean them.

Cleaning the filters

1
C
B
A
2
2. Press the on/off button to deactivate the appliance.
3. Close the water tap.
• If you do not deactivate the appliance, after 3 mi-
nutes from the end of the programme:
– All indicators go off
– The display shows 1 horizontal status bar.
• This helps to decrease the energy consumption.
Press one of the buttons (not the on/off button),
the display and the indicators come on again.
• For better drying results, keep the appliance door ajar
for some minutes.
• Let the dishes become cold before you remove them
from the appliance. Hot dishes can be easily damaged.
• First remove the items from the lower basket, then from
the upper basket.
There can be water on the sides and on the door of
the appliance. Stainless steel becomes cool more
quickly than the dishes.
3
To remove filters (B B ) and
(C C ), turn the handle coun-
terclockwise and remove.
Pull apart filter (B B ) and
(C C ). Wash the filters with
water.
A
4
Remove filter (A A ). Wash
the filter with water.
23