System Connection To Serie; Attaching The Screen Or The Adaptable Screen - VS 901 Serie Instructions De Montage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

(1)

22. System connection to Serie 901.

Attaching the screen or
the adaptable screen.
Rail for Serie 2000 screen.
Usually already installed at the factory. Slide U-mounting
brackets (1) into the position on the table mounting bracket
(2) at which square carrier ends with the table top. Screw
down in each case with two M8x25 self-tapping hexagon-
socket screws.
(2)
(1)
(3)
(5)
(4)
Serie 2000 screen.
Slide clamping block (3) of the table connection into the
function groove (clamping rail) of the screen. Position at the
desired height. Tighten three M5x12 mm TapTite screws (4)
in the clamping block Suspend the entire screen element in
cross-tube (5). Position in the linear direction and tighten
down with screw (6) (M5x16mm). Vertical alignment: the
screen element can be vertically aligned by releasing the 3
screws in the clamping block.
The adaptable screen is fine-adjusted at the adjustable feet
on the floor.
Caution! An adaptable screen is not permitted
on sitting/standing tables.
(6)
45

Publicité

Table des Matières
loading

Produits Connexes pour VS 901 Serie

Table des Matières