Securing The U-Bracket To The Table-Top Cross-Member - VS 901 Serie Instructions De Montage

(2)
(8)
3. Securing the U-bracket to
the table-top cross-member.
Assembling the various table base assemblies
(without carcass furniture)
Turn the table top over and lay it down on a clean assembly
surface (e.g. protective cover, etc.).
U-bracket round tube (1) and U-bracket square tube (8)
Connect the base assemblies to cross-member (5). Loosely
fasten locating piece (2) with two M6x16 mm hexagon-
socket screws (3) to leg connection (4). Push bracket (1)
sideways onto cross-member (5).
26
(5)
(1)
(5)
(2)
(1)
(7)
Important!
Locating piece must fit into the tube.
Firmly screw leg connection (4) and cross-member (5) to-
gether with two 6.4 washers (6) and M6x50 mm hexagon-
socket screws (7).
Important! Before screwing down, make sure the U-
bracket is aligned to the table top (flush).
Then tighten screws (3).
(2)
(3)
(4)
(5)
(6)
(7)
(4)