Fine-Adjusting And Adjusting The Table Height At Posts/Legs - VS 901 Serie Instructions De Montage

(1)
10. Fine-adjusting and adjusting the
table height at posts/legs.
Fine adjustment at the post/leg, C- and V-feet. Align the table
horizontally at adjustable glide element (1). Lift the table to
turn the adjustable glide element by hand (approx. 10 mm
vertical travel).
Fine adjustment at the disk foot. The post/leg with disk has
height-compensating screws (2). 10 mm vertical travel. Use
a VS special wrench (= offset engineer's wrench) (3).
Important! The measurement scale shows two height
indications: one for the C-foot and the other for the
center foot (post/leg / V-foot).
"Center foot" refers to all posts/legs which are mounted
centrally under the cross-member.
(2)
(3)
Post/leg, C- and V-feet with manual height adjustment
(locking mechanism).
Height adjustment is performed by raising the table to the
desired position. To reduce the table height, move the table
into the uppermost position (4) so that it can then be lowe-
red to the desired height.
Tables with electric height adjustment. Refer to separate
operating instructions.
Caution! This operation can place the table in a heavily
inclined position. Remove any objects that are not
non-slip. It is best to perform this operation on both
sides at the same time, i.e. with two persons. In the
event of a disk-foot and sideboard combination, first
move the sideboard into the middle position and release
the pivot bearing with the lever for this operation.
(4)
33