Securing The Printer Shelf To Posts/Legs - VS 901 Serie Instructions De Montage

(5)
(2)
(1)
20. Securing the printer shelf to
posts/legs.
For the post/leg with V-foot or disk.
Position flange (1) with two M6x60 mm cheese-head
screws (supplied) (2) on the rectangular tube. From the
outside, Slide up to 20 mm (5) onto the cross-member. The
holes for suspending the shelf must point outwards. Before
tightening down, suspend the shelf in the desired position
and align parallel to the table top. Then finish by tightening
down.
(5)
(4)
For the C-foot.
Remove clamp (3) for the C-foot and replace with rectan-
gular tube (4) with clamp. Ensure a spacing (5) of 20 mm.
Important! The table becomes unstable after the clamp
is released (it should be supported by a second person).
The holes for suspending the shelf must point outwards.
Before tightening down, suspend the shelf in the desired
position and align parallel to the table top. Then finish by
tightening down.
(3)
43