USRobotics USR5418 Guide D'installation Rapide page 14

English
Solution
Change the channel used by the wireless router or access point
and re-scan for wireless network devices.
Solution
Perform this ping procedure to make sure you can connect with dif-
ferent areas of the wireless network and the Internet. If at any time
during the ping procedure you do not receive a return message for
a successful ping, this means that you cannot connect to that IP
address. After you have made the corrections, continue with the
ping procedure.
1. Click Windows Start and then click Run.
2. In the Run dialogue box:
Windows XP and 2000 users:
Type cmd and click OK.
Windows Me and 98SE users:
Type command and click OK.
3. Type Ping 127.0.0.1. This is your local host address. Success-
fully completing this step ensures that the TCP/IP protocol is
installed and functioning properly. If you cannot complete this
ping, reinstall the TCP/IP protocol on your computer. Refer to
your operating system's documentation for instructions.
4. Obtain IP information for your computer (IP Address).
10