Troubleshooting - Wacker Neuson GP2500A Manuel D'utilisation

Troubleshooting

6 Troubleshooting
Problem / Symptom
If engine doesn't start, check that:
If engine starts but there is no
power at receptacles, check that:
If engine starts but runs erratically,
check that:
If the GFCI trips when a load is
connected, check that:
Reason / Remedy
Engine switch is on "Start".

Fuel valves under fuel tank and on engine are open.

Fuel tank has fuel.

Choke lever is in correct position. Choke should be closed when

starting a cold engine.
All loads are disconnected from generator.

Spark plug is in good condition.

Spark plug cap is tight.

Engine oil level is adequate.

Circuit breaker is closed.

Connector from generator to control panel is tight.

Hose routing from the fuel tank to the engine is correct. For

proper operation, the hose must run through the bushing in the
lifting bracket. Refer to the Parts Book for illustration.
The connected equipment may be wired incorrectly or faulty.

Contact equipment supplier.
See section Determining Power Requirements.

50
GP
wc_tx004575gb.fm