Cleaning - Panasonic EH-XC10 Mode D'emploi

Pore-targeted cleansing
We recommend this option for rough or clogged areas such as
the nose and chin. After completing the brush cleansing process,
continue to use this option while the foam is still on your skin.
1
1
Attach the pore focus brush.
2
2
Press the facial cleanse switch and
select a mode.
• Wash off any excess facial cleanser on your
hands.
3
3
Wash your face.
Do not press the bristles of the pore
focus brush into your skin. Lightly
apply the brush to your skin so that
 
the bristles just touch the skin and
then wash your face in a circular

motion.
• Wash your nose and chin (1 – 3) for approximately 20
seconds each.
(Notification timer feature (See page 15.))
• Do not use the brush around your eyes.
• Do not apply the appliance to the same area for extended
periods of time.
• The appliance may stop automatically for its own protection
if the foam inside it is too thick. Please rinse the inside of
the appliance lightly before using the pore focus brush.
16
4
4
After you have finished washing your face, press
the facial cleanse switch to turn off the power.
• Make sure to wash the appliance after use.
• The power will be automatically turned off approximately
1 minute after the power is turned on.

Cleaning

1
1
Rinse foam off the brush with water and then
remove.
2
2
Open the facial cleanser
compartment cover, begin
pouring water into the foam
dispenser, and then press the
facial cleanse switch to rinse.
• If a significant amount of facial
cleanser remains, the power may
turn off a few seconds after pressing
the facial cleanse switch or may not
operate smoothly. In such cases, use
warm water to clean and remove the
excess cleanser.
3
3
Press the facial cleanse switch to turn off the power.