Panasonic EH-XC10 Mode D'emploi page 15

La brosse nettoyante micro-mousse 3 en 1
Masquer les pouces Voir aussi pour EH-XC10:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 43
• The quality of foam varies depending on the type of facial
cleanser. Adjust to the recommended amount as indicated on
your facial cleanser product, or adjust the amount of water.
• Do not add anything other than facial cleanser into this
appliance. (Doing so may cause malfunction.)
• If you are using a non-foaming type facial cleanser,
moisten the brush and your face with water and apply the
facial cleanser directly onto your skin.
• Please pour liquid facial cleansers and the like into the
center of the brush. (Facial cleanser may come out from
the holes on the front side of the main body when you
pour it from the facial cleanser compartment.)
4
4
Press the facial cleanse switch and select a mode.
Foam starts to dispense approximately 5 seconds after
turning on the appliance.
• Pressing the facial cleanse switch cycles through the
"Power OFF"
"Normal (
• The mode is always set to "Normal (
is turned on.
• Wash off any excess facial cleanser on your hands.
• Add more water if the amount of foam is insufficient.
5
5
Wash your face.
• Do not apply the appliance to the same area for extended
periods of time.
• Wash your face in 3 sections as illustrated in the following
diagram for approximately 20 seconds per section.
• You can use this appliance on your neck and upper chest,
but do not apply it to your throat.
• The appliance may not operate in an ambient temperature
lower than approximately 5 °C.
)"
"Soft ( )" options.
)" when the power
Notification timer feature
Notifies you of the recommended cleansing time by
pulsing every 20 seconds.
Do not press the bristles of the soft
brush into your skin. Lightly apply the
brush to your skin so that the bristles
just touch the skin and then wash your
face in a circular motion.
If you feel irritation even if you are not
pressing the brush into the skin, stop
using the brush.
• Do not use the brush close to your
eyes.
6
6
After you have finished washing your face, press
the facial cleanse switch to turn off the power.
• Make sure to wash the appliance after use.
(See page 16.)
• The power will be automatically turned off approximately
1 minute after the power is turned on.
Note
• Please follow the same steps for the optional normal brush and
exfoliating brush. (See page 17.)
15

Publicité

Table des Matières
loading

Table des Matières