Panasonic EH-XC10 Mode D'emploi page 14

2
2
Apply make-up remover (See page 13.) to your
forehead, chin, and both cheeks.
• You can also use the appliance with make-up remover
applied directly to the warming make-up removal plate.
3
3
Once the warming make-up removal mode
indicator starts glowing, apply the warming
make-up removal plate to your skin and begin to
move it around your face.
• Lightly apply the warming make-up
removal plate to your skin and glide
around your face in a circular motion
from the inside out.
Leave areas with heavy make-up
such as around eyes as the last step
to prevent the make-up from
spreading.
Be particularly gentle when using the
appliance around the eyes.
Do not try to force the warming
make-up removal plate into hard-to-
reach areas. Use your hands to apply
make-up remover to these areas.
4
4
After the make-up remover has loosened the
make-up, press the warming make-up removal
switch to turn off the power.
• Make sure to clean the appliance with a tissue or wash
with water after every use. (See page 16.)
• The appliance will turn off automatically approximately
3 minutes after the warming make-up removal mode
indicator begins glowing.
14
Brush cleansing
Remove dead skin and dirt from pores with the gentle fine brush
and microfoam.
If you are still wearing make-up, first remove the make-up using
the warming make-up removal mode or remove eye make-up
with your hands.
1
1
Attach the soft brush by pressing
it until it clicks into place.
2
2
Open the facial cleanser
compartment and add facial
cleanser. (See page 12.)
Add the recommended amount as
indicated on your facial cleanser product
(the amount you normally use).
3
3
Fill the measuring cap with
water (approximately 4 mL)
and pour into the centre of
the brush.
Notes
• Use a foaming facial cleanser.
• Depending on the type of facial cleanser
(sticky facial cleansers, etc.) or the
amount used, the facial cleanser may not
mix properly and clog the appliance. In
rare cases, power to the appliance may
be interrupted. (See page 18.)
4 mL