Exhaust Housing Clean (Insert Only); Exhaust Blower Cleaning; Seal Checks - Napoleon NPS45 Instructions D'installation Et D'opération

10.3.4 EXHAUST HOUSING CLEAN (INSERT ONLY)

To clean the exhaust blower and exhaust housing, the appliance must be pulled out from the appliance cavity.
Remove the venting from the exhaust collar. If installed as a top vent, remove cover plate from the rear of the
housing. If installed as a rear vent, remove the cover plate from the top of the housing. Vacuum out the housing
back to blower outlet.

10.3.5 EXHAUST BLOWER CLEANING

NOTE: Do not attempt this maintenance without a
replacement exhaust blower motor mounting gasket.
A. Remove the six nuts holding the exhaust blower motor
in place.
B. Pull the motor out being careful not to damage the
wiring, unplug the two wires that are connecting the
motor and gently set aside. (The pieces of gasket may
be discarded.
C. Start by cleaning the exhaust tube by feeding a brush
or rag through the inside of the tube and out the
exhaust blower housing.
D. Vacuum out the exhaust ports and the blower housing.
E. With a bristle brush vacuum, clean the blades of the
motor.
F. Place the new exhaust blower mounting gasket around
the screw holes being very careful not to tear it.
G. Re-attach the wiring to the motor and place it back on to the housing, taking care that the side of the
motor does not tear the gasket and then re-attach the nuts.

10.3.6 SEAL CHECKS

Check for air leaks around the door, glass, and ash pan and replace gaskets as required.
Air leaks into the fi rebox will decrease the appliance's performance greatly, leading to excessive soot,
ineffi cient burning, and may even cause a malfunction.
Test the door seal by shutting the door on a piece of paper in various locations. If the paper can be easily slid
out, air may be leaking around the door seal. Carefully inspect the door gasket and door catch.
Inspect the door gasket to make sure it is fully attached. Appliance gasket cement can be used to re-attach if
necessary. If the door gasket is worn or fl attened, replace.
Check the door to make sure it latches correctly. The latch should engage with a slight amount of resistance,
yet not be too diffi cult.
If the glass is cracked, replace.
EXHAUST
BLOWER
EXHAUST
HOUSING
40.11
40.12
41
EN
NUTS
W415-1472 / A / 10.11.16