Control Adjustment - Napoleon NPS45 Instructions D'installation Et D'opération

34
ON / OFF
Use this button to turn the heater on and off.
EN
HEAT
Pressing the heat up arrow (red) will increase the heat level one setting. Pressing the heat down arrow
(white) will decrease the heat level one setting. During start-up, the power light will fl ash green and
these buttons will not respond. The red lights at the top left of the control will indicate the heat setting
1 through 5.
FAN
Pressing the fan up arrow (red) will increase the fan speed one setting. Pressing the fan down arrow
(white) will decrease the fan speed one level. While adjusting the fan speed, the red lights will tempo-
rarily indicate the fan speed then fl ash back to the heat level.
AUGER FEED
Pressing and holding this button will turn the auger, speeding the feed of pellets into the burn pot.
This is convenient when using the heater for the fi rst time or when you have completely emptied the
hopper and need to restart the heater.
8.6

CONTROL ADJUSTMENT

FEED TRIM
Both the combustion fan speed and the feed rate have been factory set but may need to be adjusted
(trimmed) on site. Due to the variables (i.e. vent size and length, pellet quality), the factory settings may not be
correct for every installation. To help keep the fl ame from extinguishing on the minimum heat level, the feed
rate can be trimmed when in normal operation (after start-up cycle). Depress and hold the auger button while
you push the heat up or down buttons. This will slightly increase the amount of fuel being fed into the burn
pot. When trimming the feed rate, the LED's will display the factory setting (#3 light) with the ability to increase
up two levels (#4 and #5 light) or decrease (#2 and #1 light) the length of time between the auger feed cycle.
FAN TRIM
Similar to the feed rate, it may be necessary to trim the speed of the combustion blower. Due to specifi c
installations, it may be necessary to increase or decrease the amount of air moving through the burn pot to
achieve maximum effi ciency. When in normal operation depress and hold the auger feed button. Similar to the
feed trim the LED's indicate what setting the trim feature is set to (#3 light is the factory setting). To adjust the
fl ow, push the fan up or down buttons while depressing the auger feed button.
W415-1472 / A / 10.11.16