ESAB PT-20AMX Manuel D'instruction page 89

SeCTION 3
Installation
Installing Front end Parts
WARNING
Make sure power switch on
console is in OFF position and
primary input power is de-en-
ergized.
NOTe:
Part numbers in parenthesis ap-
ply to "CE" / European units only.
1. The seat comes assembled to the front end of the torch. IF the seat becomes
damaged, the torch body must be replaced. DO NOT attempt to remove the seat
from torch body.
2. Electrode holder assembly 21332 (4485840) includes the baffle tube 21374
(4485834). If baffle tube becomes damaged, it can be replaced by un-threading the
damaged tube out of the holder. Use small hex end of the wrench 21375 (4485842)
in hex broach on the tube. Tighten tube securely but do not over-tighten.
89
Seat
Electrode Holder Assembly
Baffle Tube
INSTAllATION