ESAB PT-36 Manuel D'instruction page 159

sEctIoN 5
7. Remove electrode holder from torch body. Hex on the end of the electrode holder removal tool will engage
in a hex in the holder.
8. Disassemble electrode holder and gas baffle. Carefully remove O-ring from electrode holder and slide baffle
from holder. Inspect nozzle seating surface (front edge) for chips. Look for cracks or plugged holes. Do not
attempt to clear holes. Replace baffle if damaged.
Check all O-rings for nicks or other damage that might prevent O-ring from forming a gas/water tight
Torch Body
Electrode Holder
Pull Gas Baffle back
to remove and access
o-ring
Removal Tool
NotE:
seal.
O-ring (located underneath baffle)
Gas Baffle
159
MaINtENaNcE
Electrode Holder