Chain Counter Setting Menu; Measurement Menu; Alarm And Functions Menu - Lofrans THETIS 7003 Manuel D'installation Et D'utilisation

4.2 Chain counter setting menu

Hold down the (ON) key for six seconds to
access the instrument setting menu. The following
page will appear on the display:
Use the (DOWN) and
move around the menu options.
Once you are positioned on the item to be modified press the
Use the (DOWN) or
Once one is positioned on the parameter press the
According to the type of parameter, using the
same or disable/enable the function.
Once the modification has been performed, press the
Using the (DOWN) key go to the Exit option and press the
procedure must be used to return to the main page.

4.3 Measurement menu

Measure
O f f
R e s e t M e a s u r e
U n i t s
E x i t

4.4 Alarm and functions menu

8
(UP) keys to
(UP) keys to move from one parameter to another.
(DOWN) and
Use the
OFF
Turn the unit OFF
Reset Measurement
Resets the chain measurement value (0.0).
N o
Units
F e e t
Selects the unit of measurement:
Exit
To return to the settings menu.
Use the
Up Alarm
It is possible to enable the function and establish the
height at which the anchor-winch stops; After you must
release the up button to continue to other function.
Settable values: 1.0 - 1.5 - 2.0...5.0 (metres or feet).
Load Default
This function allows the User to revert to the original
factory default settings, thus erasing all settings
memorised.
This command must only be used in the event of
programming errors.
Exit
To return to the settings menu.
(ON) key to confirm your choice.
(ON) key to enable modification.
(UP) keys it is possible to reduce/increase the value of the
(ON) key to confirm.
(ON) key again to return to the setting menu. The same
(DOWN) or (UP) key to move around the parameters
Feet/ inches
Metres / centimetres
(DOWN) or (UP) key to move around the parameters
THETIS 7003
Menu
M e a s u r e
A l a r m s & F u n c t i o n
S e t t i n g s
L a n g u a g e
S e n s o r C a l i b r a t i o n
Confirm with
Select with
= Yes = No
Confirm with
Select with
= Feet = Metres
Confirm with
Confirm with
Select with
Select value with
Confirm with
Select with
= Yes = No
Confirm with
Confirm with