www.lofrans.com
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept an interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliancecould void the user's authority to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To maintain compliance
with FCC RF exposure compliance requirements, please follow operation instruction as documented in this manual.
2.2 General dimensions
2.3 Contents of the package
The Radio Control Chain counter includes:
1 Transmitter, radio-chaincounter
1 Receiver, base unit
1 Power adaptor for lithium-ion battery charging
1 Magnetic sensor
Federal Communication Commission
Interference Statement
3 8mm
5 8
mm
1 Magnet for the windlass
1 Horizontal shaft anchor windlass sensor support
1 Cradle with 2 screws for radio-chaincounter
1 User manual
UK
5