Door Removal - Electrolux ECFD3068AS Instructions D'installation

30" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
7. Use the following distances for the distance from
the side of the appliance to the bracket holes.
8. After having positioned and leveled the appli-
ance, move the bracket close to the rear of the
appliance and anchor it to the floor using the two
washers and screws. A qualified technician must
verify the suitability of the materials in accor-
dance with the type and condition of the floor.
9. Push the cooker towards the wall, and at the
same time, insert the bracket in the plate that is
fastened to the rear of the appliance.
WARNING
The rear vent trim has 3/16"
(5 mm) standoffs to keep the appliance slightly
away from the back wall. Do not remove or tamper
with standoffs due to potential temperature issues.
10. Check for proper installation and use of the anti-
tip bracket. Carefully tip the range forward by
pulling it from the back to ensure that the anti-tip
bracket engages the range leg and prevents tip-
over. The range should not move more than 1"
(2.5cm).

Door removal

It is not necessary to remove the door in order to
install the range, but is an added convenience.
Refer to the Use and Care Guide for the oven door
removal instructions.
19