Wheel Spin (Without Guard); Wheel Spin (With Guard) - TECO 680 Manuel D'utilisation

Note:
- automatic width acquisition is re-enabled only with a new acquisition of the automatic
internal measuring arm;
- if the wheel guard is closed or in the case of a fault of the sensor located on the guard,
the machine will automatic set-up for manual width entry when the internal measuring
arm is moved to the rest position;
- at the end of the spin, it is possible to change the width acquired automatically by the
machine by selecting the following icon on the work page:
IMPORTANT
bear in mind that the wheel's rated diameter (e.g. 14") refers to the planes
on which the tyre beads rest, which are obviously inside the rim. The val-
ues measured are with reference to external planes and, as a result, are
smaller than the nominal values due to the thickness of the rim itself. The cor-
rection value therefore refers to an average thickness of the rim. This means that
the data measured on wheels with different thicknesses may vary slightly (2 or 3
tenths of an inch maximum) from the rated values. This is not a lack of accuracy
of the measuring devices, but reflects reality.
If the automatic measuring arm fails to operate, the geometric data can be entered
manually by following the procedure indicated in the "manual wheel data entry" section,
function present within the utility and configuration programmes.

WHEEl SPin (without guard)

1
Press the key on the keypad together with the button on the left side and hold
S TART
them down until the braking phase starts. If one or both of the buttons is released during
the start of the spin or during measurement, the message "A Cr" is displayed and the
brake is applied automatically.
CAUTION
Do not operate the machine without the guard and/or if the safety device has been
tampered with.
CAUTION
During machine use, personnel may not be present in the area enclosed by the section-
ing in Fig. 7a.

WHEEl SPin (with guard)

Wheel spins take place automatically by lowering the guard or pressing the Start button
with the guard lowered.
90
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
.