Wheel Data Entry - TECO 680 Manuel D'utilisation

IMPORTANT
In case of failure of the automatic locking device, it is possible to remove the wheel that may
be present on the machine acting on the rear side of the body as indicated in Figure 14b:
In machines where the adjustable discharge A of figure 14c
is also present on the rear side of the body, it is possible
to remove the wheel possibly present on the machine by
proceeding as follows:
- Close the adjustable drain A (fig. 14c);
- blow compressed air on the fitting b in the figure;
- restore the correct functioning of the wheel locking de-
vice: return the adjustable drain A in the conditions prior
to closing.

WHEEl DaTa EnTrY

Wheel data entry for wheel balancers without ultrasonic sensor
The machine allows for the diameter and distance values to be entered automatically;
the width value can be entered using the keypad.
- bring the automatic measuring arm into contact with the inner side of the rim (Fig.15).
Take great care to position the arm correctly so as to ensure accurate data reading.
- Keep the arm in contact with the rim until the machine has acquired the wheel's diameter
and distance values. The following screen appears during this phase:
86
15
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
14a
14b
14c