TECO 680 Manuel D'utilisation page 73

600
assembly of the ultrasonic sensor and its "optional accessory
supplied on request" support for automatic width measurement
- Insert the ultrasonic sensor cable inside the slots in the metal pipe (see Fig. 9)
CAUTION
to facilitate the access of the cable in the slots on the metal tube, it is advisable
to remove the tube from the rotation pin by unscrewing the M12 screw present.
- Fasten the ultrasonic sensor to the guard pipe with the three M6 screws included (Fig. 9a).
- Connect the sensor cable to the connector on the side of the casing (A, Fig. 9b).
- Adjust the length of the ultrasonic sensor cable near the connector (A, fig.9b) with
protection closed, to avoid deformation of the connector during the movement of the
wheel guard.
Then lock the cable using the supplied clamp (A, fig.9). Any excess of the cable in que-
stion must be inserted and locked (using the bases already present) inside the sensor
support. To access the sensor support, remove the plastic casing by unscrewing the
four fixing screws (Fig.9c).
- check and eventually act on the ultrasonic sensor support until the required distance
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
600
300
7
8
600
1000
7a
9
73
EN