TECO 680 Manuel D'utilisation page 100

of particularly large spokes;
- static mode; just one balancing weight, divided, if necessary, into equal parts on the two
sides; procedure described in the STATIC bALANCING section.
Proceed as follows to balance a motorcycle wheel on two planes (dynamic balancing)
using clip weights:
- fit the motorcycle wheel adapter on the wheel balancer (A Fig.23);
• insert the two screws provided into the holes on the wheel contact flange;
• tighten the screws on the adapter making sure that it rests on the flange correctly;
• mount the motorcycle shaft on the adapter
• mount the wheel after selecting the centring cones (one for each side of the wheel),
tighten with the appropriate ring nut using the spacers necessary for coupling the secur-
ing cones to the threaded part of the shaft.
IMPORTANT: the wheel must be fixed to the flange so as to avoid any movement of the
two during the spin or braking phases.
- Select the balancing programme icon
the MOTORCYCLE environment.
- Fit the appropriate extension on the inner measuring arm, (Fig. 23 a).
- Set the wheel data as usual.
- Proceed as described for dynamic balancing.
Proceed as follows to balance motorcycle wheels dynamically using adhesive weights:
- follow the instructions for mounting the motorcycle adapter described in the MOTORCY-
CLE DYNAMIC PROGRAMME;
- follow the instructions above for the "Motorcycle Dynamic" programme;
- perform a spin;
100
motorcycle Dynamic programme
23
motorcycle alU programme
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
and then press the ENTER button to set
23a