TECO 680 Manuel D'utilisation page 114

- Select the Firm data setting icon
- The screen displays a page where the data can be set, comprising:
• 4 lines on which data can be entered (in the centre of the screen);
• a keypad for setting characters;
• 5 control icons;
• 1 icon for exiting the programme;
• 1 help icon.
- Select the character you intend to enter in the circular area on the screen.
- Confirm selection by pressing the Enter
Control icons are:
Go to next line:
used for moving the cursor to the next line. If a word has already been entered on the
new line, the word will be deleted automatically.
Go to previous line:
used for moving the cursor to the previous line. If a word has already been entered on
the new line, the word will be deleted automatically.
Delete last character entered:
moves the cursor back to the left so that the character is deleted.
Set upper case/lower case characters:
selects upper case or lower case characters, alternately.
The set data is stored when the programme is exited, i.e. by selecting the Exit
You are advised to set your own surname and name on the first line, the name of the city
on the second line, the street on the third line and the telephone number on the fourth line.
lighting lED activation/deactivation
It is possible to activate or deactivate the LED light when present on the machine.
After the list of the setting programmes is displayed:
- Select the lighting LED activation/deactivation icon
- Three icons will appear on the display that represent the possible light modes, as shown
below:
LED1. In this configuration, the light turns on when:
- at the end of a spin cycle if residual unbalances are present for 30 seconds;
- in CP (centred position) for an additional 30 seconds.
114
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
.
button.
icon.