TECO 680 Manuel D'utilisation page 110

- Three icons will appear on the display that represent the possible positions, as shown
below:
H12: the balancing weight must always be applied in the 12 o'clock position regardless of
the type of balancing programme selected or the type of weight to be applied (adhesive
or spring);
LASER: the balancing adhesive weight must be applied in correspondence of the laser
line (in all balancing programmes) whereas the clip weight must always be applied in the
12 o'clock position;
CLIP: the balancing adhesive weight must be applied using the weight holder in ALU1 and
ALU2 programmes, whereas the spring weight must always be applied in the 12 o'clock
position.
- Select the desired position with the cursor keys. The selected icon is enabled if it is in the
following confi guration:
- Press the Exit button to save the setting and exit
The selected confi guration is displayed on the status bar in the working environment.
In the case in which the laser line is faulty, the balancing adhesive weight is possible to
apply it to 6 hours (Table A), while the spring always weight to 12 hours.
- On the screen appear the three icons that represent the possible positions as shown
below:
The selected icon is enabled if it is presented in the following confi guration:
TYPE bALANCING
PROGRAM
ALU1 / ALU 1P
110
TABLE A
ADHESIVE WEIGHT
APPLICATION
POSITION PLAN A
LASER
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
.
H6
o
ADHESIVE WEIGHT
APPLICATION
POSITION PLAN b
H6
o
LASER