Sharpening Scissors; Changing The Grinding Wheel; Cleaning And Maintenance - Parkside PSS 65 B1 Traduction Des Instructions D'origine

Sharpening scissors

The device is not suitable for grind-
ing serrated scissors. The device
is not suitable for grinding pinking
shears.
1. Mount the selected sharpener (2)(see
Mounting sharpener).
2. Completely open the scissors.
3. Turn the machine on.
4. Insert one of the scissor blades into the
grinding slot.
5. Using light pressure guide the blade
from the screw up to the tip along the
grinding wheel (10).
6. Remove the scissors from the sharpen-
ing station and turn the scissors to
sharpen the other blade.
7. Insert the other scissor blade into the
grinding slot.
8. Using light pressure guide the blade
from the screw up to the tip along the
grinding wheel (10).
9. Execute the alternating grinding pro-
cess until the cutting edges are burr-free
and sharp.
10. Switch the device off and wait for the
grinding wheel (10) to stop.

Changing the grinding wheel

Information on replacement:
• Never operate the device without
protective equipment.
• Ensure that the grinding wheel di-
mensions match those of the device.
• Never use separate bushings or
adapters in order to make grind-
ing wheels whose hole is too
large fit the device.
• Do not use any saw blades.
• Always reassemble the device
completely after replacing the
grinding wheel.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
When the grinding disc nut (16) is
being tightened or loosened, the
grinding disc (10) must be held firm
by hand or the axle held firmly in
place with a pair of pliers.
1. Release the grinding wheel
nut (16) in the clockwise di-
rection (left-handed thread).
2. Remove the grinding wheel (10).
3. Set up a new grinding wheel (10).
Screw the grinding wheel nut (16) in
the anti- clockwise direction (left-hand-
ed thread).
4. Test run: Before starting work and af-
ter each change of grinding disk, carry
out a test run of at least 60 seconds
with no load. Switch off the equipment
immediately if the disk runs lumpy, sub-
stantial vibrations occur, or abnormal
noises are generated.
Cleaning and
maintenance
Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described
in these instructions carried
out by a specialist workshop.
Use only original components.
Allow the equipment to cool
before carrying out any main-
tenance and cleaning work.
There is a risk of burns.
GB IE
27