Invisible Zipper Foot - Bernette Sublime London 5 Mode D'emploi

2 3 5
EN

Invisible zipper foot

This foot is available as special accessory.
This foot is used to insert invisible zippers so
that they are covered by the seam, and thus
hidden. Attach the invisible zipper foot to the
machine. Adjust needle center position and
straight stitch. Stitch length depends from
the fabric. Adjust 1,0 - 3,0 mm. Place open
zipper face - down on right side of fabric as
shown in picture 1.
Place the fabric edge at the 5/8 inch marking
line on the needle plate surface. Place the
zipper 1/4 inch below raw edge of garment.
With right-hand groove of foot over coil,
stitch zipper until the foot hits the slider.
Remove the garment from the machine.
To attach the other half of the zipper, place
the fabric edge on the 5/8 inch marking line
on the needle plate as shown in picture 2.
With the left-hand groove of foot over coil,
stitch zipper until the foot hits the slider.
Close zipper. Fold the fabric that the zipper
is on ride - hand side out of the way as
shown in picture 2.
8VH D SLQ IRU ¿[LQJ WKH IDEULF &KDQJH WR
regular sewing foot and saw as close as
possible with straight stitch against the
zipper.
At last carry out tie off with some forward
and reverse stitches.
Please note:
1R 6 PDUNLQJ LV VKRZQ RQ WKH VWLWFK OHQJWK
GLDO E\ /RQGRQ