Pentair Sand Dollar SD40 Guide D'installation Et D'utilisation page 4

Système de filtration à sable
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ii
WARNINGS AND IMPORTANT SAFETY PRECAUTIONS
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION:
all applicable local codes and ordinances. Improper installation may create an electrical hazard
which could result in death or serious injury to pool users, installers, or others due to
electrical shock, and may also cause damage to property.
injury or death. These risks may include but not be limited to electric shock, fire, flooding,
suction entrapment or serious injury or property damage caused by a structural failure of
the pump or other system component.
Never exceed the maximum stated pump flow rating.
Only use a pumping system rated for the corresponding flow. FAILURE TO DO
SO CAN RESULT IN HAIR OR BODY ENTRAPMENT WHICH CAN CAUSE
SERIOUS PERSONAL INJURY OR DEATH. If in doubt about the rating of your
system, consult a qualified pool service professional.
entrapment drain cover must be used for each drain. Pools and spas should utilize a
minimum of two drains per pump.
and advanced weathering. If a cover becomes loose, cracked, damaged, broken
or is missing, close the pool or spa immediately,
and keep the pool or spa closed until an appropriate VGB 2008 certified cover is
properly installed. Covers deteriorate over time due to exposure to sunlight and
pool chemicals. This cover must be replaced within seven (7) years from
installation (or earlier if the cover becomes damaged in any way).
Pump and Sand Filter System Installation and User's Guide
High Pressure from the sand filter can cause severe injury or
major property damage due to tank separation.
Release all pressure and read instructions before working on
the sand filter. If the filter clamp is adjusted under pressure,
the tank can separate, causing serious injury or major
property damage.
BEFORE WORKING ON FILTER!
(1) Stop pump.
(2) Open air release valve.
(3) Release all pressure from system.
PUMPS REQUIRE HIGH VOLTAGE WHICH CAN SHOCK, BURN,
OR CAUSE DEATH.
BEFORE WORKING ON PUMP!
Always disconnect power to the pool pump at the circuit
breaker before servicing the pump. Failure to do so could
result in death or serious injury to service person, pool
users or others due to electric shock.
A pool or spa pump must be installed by a qualified pool and spa
service professional in accordance with the National Electrical Code and
Pumps improperly sized or installed or used in applications other
than for which the pump was intended can result in serious personal
Pumps are not a substitute for properly installed and secured pool
drain covers. An ANSI/ASME A112.19.8 approved anti-
Regularly inspect all covers for cracks, damage
shut off the
pump, post a notice

Publicité

Table des Matières
loading

Table des Matières