Pentair Sand Dollar SD40 Guide D'installation Et D'utilisation page 11

F. The pump may now be attached to the pump support side of the base.
The pump should be oriented as indicated in Figure 2.
PUMP END OF SYSTEM BASE
RELEASE LATCH
Figure 2.
G. Slide the pump foot between the claw fasteners and the release latch.
See Figure 3. Seat the pump by pushing down on it until the release
latch clicks into place on the pump foot. See Figure 4. The pump
should be positioned as indicated in Figure 5. Install the two
#20 x 1-1/4" long lag bolts through the slots in the foot of the motor,
into the two holes in the base near the release latch.
Release latch
Figure 3.
ORIENT THE PUMP
WITH THE
STRAINER POT
FACING IN THE
DIRECTION OF
THE ARROW
CLAW FASTENERS
Pump and Sand Filter System Installation and User's Guide
FILTER END OF
SYSTEM BASE
Claw fastener
5