Electrical Requirements - Jenn-Air Euro-Style JS42SSDUDE Mode D'emploi

The water shutoff should be located in the base
cabinet on either side of the refrigerator or some
other easily accessible area. If the water shutoff valve
is not in the cabinets, the plumbing for the water line
can come through the floor. See "Water Supply
Requirements" for more information.
80" - 90"
(203-229 cm)
83¹⁄ " (212.1 cm) min.
2
84³⁄ " (215 cm) max.
4
to bottom of solid soffit
(see chart following)
6"
(15.2 cm)
24"
(60.96 cm) min.
Width A
Model
(as shown above)
41¹⁄ " to 41³⁄
2
42
(105.4 cm to 106.1 cm)
47¹⁄ " to 47³⁄
2
48
(120.7 cm to 121.3 cm)
NOTE: Flooring under refrigerator must be at same level
as the room. Face of cabinetry must be plumb.
6
B
Dimension
77"
(196 cm)
A
Width
6"
(15.2 cm)
1"
6"
(2.54 cm)
(15.2 cm)
Dimension B
(as shown above)
"
4
7¹⁄ " (19.1 cm)
2
"
4
13¹⁄ " (34.3 cm)
2

ELECTRICAL REQUIREMENTS

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it
is important to make sure you have the proper electrical
connection.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a similar
qualified person. Do not use a cord that shows cracks or
abrasion damage along its length or at either the plug or
connection end.
RECOMMENDED GROUNDING METHOD
A 115 V, 60 Hz, AC only, 15 or 20 A fused, grounded
electrical supply is required. It is recommended that a
separate circuit serving only your refrigerator be provided.
Use an outlet that cannot be turned off by a switch. Do
not use an extension cord.
IMPORTANT: If this product is connected to a GFCI
(Ground Fault Circuit Interrupter) protected outlet,
nuisance tripping of the power supply may occur,
resulting in loss of cooling. Food quality and flavor may
be affected. If nuisance tripping has occurred, and if the
condition of the food appears poor, dispose of it.
NOTE: Before performing any type of installation or
cleaning, remove the top grille and turn the master power
switch to OFF or disconnect power at the circuit breaker
box.
When you are finished, turn ON the master power switch
or reconnect power at the circuit breaker box. Then reset
the control to the desired setting.