Adjust Doors - Jenn-Air Euro-Style JS42SSDUDE Mode D'emploi

5.
Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.54 cm)
of the top soffit.
NOTE: If an anti-tip board has been used, adjust the
leveling legs until the top of the refrigerator is within
1/4" (6.35 mm) of the bottom of the anti-tip board as
shown. Do not crush the compressor cover.
2" (5 cm)
D
A. Center board 1/4" (6.35 mm) max. above refrigerator
B. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
IMPORTANT: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with
the door alignment or top grille fit. To avoid damage to
the cabinet or leveling legs, do not apply more than 50
inch-pounds (5.65 Nm) of torque to the leveling bolts. The
leveling legs can be extended to a maximum of 1¹⁄
cm) below the rollers.

ADJUST DOORS

DOOR HEIGHT ADJUSTMENT
Use the following steps to adjust the door height, up or
down, after the doors have been leveled.
1.
Open the freezer or refrigerator door and locate the
bottom hinge.
2.
Remove the door stop screw from the bottom side of
the hinge with a 3/8" open end wrench.
A
A. Bushing
B. Door stop screw
C. Locking plate
A B
C
1/4"(6 mm)
max.
B C
3.
Remove the locking plate as shown.
4.
Using a 1/2" open end wrench, turn the bushing
located underneath the bottom of the hinge.
Turn the bushing to the left to lower the door.
Turn the bushing to the right to raise the door.
5.
After adjusting, check the doors to make sure they
are even across the top and bottom. If the doors are
not even, continue to turn the bushing to adjust the
door height.
6.
Replace the locking plate.
7.
Turn the bushing slightly to align the hinge and
locking plate screw holes.
8.
Replace the door stop screw or screws and tighten.
9.
Recheck to make sure the doors are aligned and
even.
DOOR SWING ADJUSTMENT
1.
Check that the refrigerator door can open freely.
If the door opens too wide, remove the door stop
screw or screws (depending on your model) from the
bottom hinge. See "Door Height Adjustment" earlier
" (3.18
4
in this section.
2.
Hold the door open to a position that is less than 90°.
3.
Replace the door stop screw or screws in the bottom
hinge and tighten.
A B C
A. 130°
B. 110°
C. 90°
15