Installation Instructions; Unpack The Refrigerator; Reduce Tipping Radius; (If Required) - Jenn-Air Euro-Style JS42SSDUDE Mode D'emploi

Réfrigérateur encastré côte à côte
Masquer les pouces Voir aussi pour Euro-Style JS42SSDUDE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

UNPACK THE REFRIGERATOR

WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT:
 Do not remove the film covering until the refrigerator
is in its operating location.
 All four leveling legs must contact the floor to support
and stabilize the full weight of the refrigerator.
 Keep the cardboard shipping piece or plywood under
the refrigerator until it is installed in the operating
location.
1.
Remove and save the literature package bag taped to
the side of the refrigerator and the parts bag behind
the grille. Remove the four brackets (two on each
side) that attach the shipping base to the refrigerator
bottom.
NOTE: Do not remove tape and door bracing until the
refrigerator is in its final location.
2.
If necessary, reduce the tipping radius. See "Tipping
Radius" for ceiling height requirements or "Reduce
Tipping Radius" for step-by-step instructions. If you
do not need to reduce the tipping radius, proceed to

"Move the Refrigerator into House."

10

INSTALLATION INSTRUCTIONS

REDUCE TIPPING RADIUS

(IF REQUIRED)

Before bringing the refrigerator into the home, be sure
there is adequate ceiling height to stand the refrigerator
upright. See "Tipping Radius" in the "Installation
Requirements" section for more information.
If you do not have adequate ceiling height to stand the
refrigerator upright, the tipping radius can be reduced by
removing the top grille and side trims (see the following
chart).
Model
42
48
1.
Grasp both ends of the top grille.
2.
Push the top grille straight up; then pull straight out.
Lay the grille on a soft surface.
B
A. Top grille
B. Cabinet side trim
3.
Remove the 6 screws attaching each cabinet side
trim to the refrigerator and remove the side trims.
MOVE THE REFRIGERATOR INTO HOUSE
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
1.
Place an appliance dolly under the left side of the
refrigerator as shown. Place the corner posts from
the packing materials over the trims and handles
as appropriate to avoid damage. Slowly tighten the
strap.
Reduced Tipping Radius
90¹⁄
" (229.9 cm)
2
91¹⁄
" (231.8 cm)
4
A
B

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pro-style js42ppdudeEuro-style js48ssdudePro-style js48ppdude

Table des Matières