Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DOOR-TO-DOOR OR DOOR-TO-REFRIGERA-
TOR TRIM ADJUSTMENT
1.
Loosen, but do not remove, the four Torx 27
flat-head mounting screws. Remove and discard the
two 1/4" hex-head mounting screws.
2.
Adjust the top hinge of either door to align it with the
other door or the refrigerator trim.
3.
Tighten the four Torx 27 flat-head mounting screws to
a torque of approximately 100 inch-pounds (11.3 Nm).
B
A. Torx 27 flat-head mounting screws
B. 1/4" hex-head mounting screws
INSTALL SIDE PANEL
If the built-in area depth is 25" (63.5 cm) or more, the side
panels can be installed inside the side trim or attached to
the outside of the side trim.
IMPORTANT: JennAir is not responsible for the removal or
addition of molding or decorative panels that would not
allow access to the refrigerator for service.
1.
For the inside side trim piece, slide the front edge of
the routed side panel into the trim piece.
2.
Nail the rear edge of the panel to the support board.
A
B
A. Support board (mounted to back wall)
B. Cab side trim
16
A
INSTALL BASE GRILLE
There are two pieces to the base grille to allow for a
custom fit: the base grille itself and the skirt. The skirt can
be added to the base grille in order to extend it all the
way to the floor.
1.
To see whether the skirt is needed, place the base
grille into position. Do not attach the base grille to
the refrigerator. Measure the distance between the
bottom of the base grille and the floor. The gap must
be a minimum of 1/2" (1.27 cm) in order to add the
skirt.
NOTE: If the gap measures less than 1/2" (1.27 cm),
skip steps 3 and 4 of the instructions, and install the
base grille only.
2.
Remove the film from the base grille.
3.
Snap the skirt onto the base grille.
4.
Trim the skirt by scoring the proper "V" groove with a
utility knife. Break the skirt at the score line.
A."V" groove
5.
Using the two screws, attach the base grille assembly
to the refrigerator as shown.
NOTE: Drive in the right side screw first.
A
A. Screws (2)
A
B
A. Base grille
B. Skirt
A
Publicité
Table des Matières
