Moving The Machine - BH FITNESS S1RiB Guide D'utilisation

STEP 6
1) Slide the Back Rest (N-1) down on to Back Rest Post (M-1). Make sure the knob that tightens the back
rest is loosened. Pull out the knob to slide the back rest onto the Back Rest Post (M-1). Secure the back rest
by seating the back rest adjustment knob into one of the pre-drilled settings and tighten the knob.
18
S1RiB_Manual_Bilingual.indd 18-19
STEP 7
1) Connect Cable Connector (upper) (B-2) to
(A-3) Computer Cable and then connect Heart
Rate Cables (upper) (B-3) to Computer (A-1)
(See Figure 1). When connecting the Heart Rate
Cables there is not a left or right cable, connect
either side.
2) Install the Computer (A-1) to the computer
bracket which is welded on the top of the
handlebar post. Secure the computer with 4
screws (A-2).
3) While seated, lift the seat adjustment bar
located under the right side of the seat. Using
your legs, slide the seat forward or backward until
in the correct position. Once the correct position
is set, release the seat adjustment bar to lock the
seat in place.
4) For electric power, plug in the Adapter (R-5)
into the front of the machine.
M-1

MOVING THE MACHINE

To move the machine to a new location, tilt the bike forward and roll the machine on the transport wheels.
19
11/1/2016 10:59:06 AM