Hendi 154601 Mode D'emploi page 11

Turning off the gas griddle
•
Turn the knob completely to the right. The burner will go off.
Note! After turning off the burners, wait approximately 10 minutes before reigniting the burners.
After turning off the burners, always turn off the main tap on the gas cylinder and the tap on the appliance!
Cleaning and maintenance
•
Let the appliance cool down before cleaning
•
Beware: Never immerse the appliance in water or any other liquid!
•
Clean the outside of the appliance with a damp cloth (water with mild detergent).
•
The grid and/or baking tray of the grill should be cleaned regularly. Let it soak in cleaning agent first, then use an
abrasive material like a scourer or wire brush. If you use special barbecue cleaner, follow the instructions on the
packaging.
•
Clean the ventilation slots (if applicable) with a vacuum cleaner.
•
Keep inside after use.
•
Let specialised personnel clean at least once a year the burner.
•
Never use a high pressure cleaner.
•
Maintenance after every use:
Fault
Burner will not ignite:
Note
•
It is to be recommended to replace the gas hose after 3 or 4 years (see date shown on hose). The gas hose becomes
porous after a time. Also check the hose for leaks on a yearly basis at least. Even if the expiration date has not been
expired yet, you must check the condition of the hose always. In case of damage/cracks you have to replace the hose
immediately. Please make sure that you comply with all local health and safety regulations (e.g. fire code).
•
Pressure regulators have a default maximum life span as indicated by the date printed on the regulator, but please
note that local health and safety regulations may overrule this.
•
Only replace the pressure regulator with one provided by the manufacturer.
•
Consult the local regulations, these may differ.
•
Always store gas bottles upright, in use as well as when empty.
Clean the griddle.
Clean the grease holder.
Possible cause
Defective igniter
Defective thermocouple
Dirty sparking plug
Defective pressure regulator
Empty gas cylinder
Kink in gas hose
Clogged jet
Fault
Burner does not burn fully:
Possible cause
Gas cylinder is (almost)
empty
Kink in gas hose
The main gas tap on the gas
cylinder is not fully open
Main jet clogged
Defective gas tap