GARDEO PRO GRO20V20WIFI-2A Traduction Des Instructions D'origine page 137

TROUBLESHOOTING:
NOTE: For any fault of the machine, please always check the charging station first, to see if it is
under proper working status(fence line is not loosen, or bite by your pets, or cut by the blades of
the machine, or your AC power shut down when the machine is working). The lamp on the charging
station will be red flashing if there's such problem.
1. The mower does not start.
a) The mower starts in an ineffective fence line area. Check the fence line for repair.
b) Check the emergency stop switch. If the emergency stop switch is locked, press the
emergency stop switch then press red power switch.
c) If the mower has not been used for a long while, the battery may be empty. Make sure to
charge it again after charging. Even when unused, it is recommended that the battery is
charged every 3 months.
d) Turn off the mower, wait 5 seconds, start again.
2. The mower does not move forward.
a) The bumper sensor may be damaged.
b) If the grass is very long(more than 12cm) at the first time, which will shelter the sensor
tube, please mow the grass with a traditional lawn mower before using the robot mower.
3. The mower does not mow properly or at all.
a) Turn off the mower. Check if the blades are properly installed.
Replace the blades if damaged.
b) If the mower is in a slope which has an angle more than 20 o, the mower will
automatically stop.
c). The root part of the blade holder is stuck by objects or grass. Remove them and restart.
d) The grass is too dense to be mowed due to the automatic protection of machine.
e) the machine stopped automatically to protect the PCBs and other components when it
tested the motor temperature is too high.
4. The mower crosses the fence line and continues outside the perimeter.
a)The fence line turn angle is too steep. The inner angle must be at least 125 o.
b) The fence line is too close to a slope. Adjust the fence line position to be in accordance to
the recommendations.
c) The fence line signal is weak. The fence line must not exceed 200m. If you bury the fence
line into the soil, make sure it's no deeper than 2cm.
d) Check if there are any high-power appliance(such as transformer,
generator,telecommunications tower, etc.) nearby. Those appliances could interfere the
machine signer.
5. The battery is not charging, or the mower does not charge properly, it bumps the
charge station again and again.
a) The extruding poles of the charger are not in contact with the paddles of the charging
station.
b) The extruding poles or the paddles are dirty. Clean them. (Make sure to disconnect the
power before cleaning.)
c) If long time no charge, the left power will be exhausted by itself. If the battery broken a
little you can re-charge many times to active the battery or you can change the battery.
d) The sensor of the machines is damaged.
137