Fireplace Installation; Framing - Dimplex XLF50 Manuel Du Propriétaire

Fireplace Installation

CAUTION: Ensure installation
does not allow fireplace to be
in direct contact with building
vapor barrier or insulation and
meets all local building code.
!
NOTE: A dedicated, properly
fused 15 Amp circuit is
recommended, rated for the
appropriate voltage (120V,
240V). A dedicated circuit will
be required if, after installation,
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
WARNING: Construction
and wiring must comply with
local building codes and other
applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
WARNING: To reduce the
risk of fire, do not store or use
gasoline or other flammable
vapors or liquids in the vicinity
of the heater.
1. Select a location that is not
susceptible to moisture and is
away from drapes, furniture and
high traffic.
www.dimplex.com
2. Unpack the fireplace and
hardware from the box.
!
NOTE: Leave the front glass
and partially reflective glass
safely in the box until the time
you are ready to install them.
3. Store the fireplace in a safe, dry
and dust free location until you
are ready to install the fireplace.

Framing

CAUTION: Two people will be
required for various steps of this
procedure.
This design of this unit allows
three options for installation:
partial recess, flush mounted or
sub-surface mounted.
CAUTION: Sub-surface
mounting should be limited
to ½ in. (13 mm) to ensure
adequate air flow of heated air
out of the firebox area.
7