Machine Installation; Uncrating Machine; Installing Batteries - Nobles Speed Scrub 2701 Opérateur Manuel Et Liste Des Piéces

MACHINE INSTALLATION

UNCRATING MACHINE

1. Carefully check the shipping crate for signs of
damage. Report damages at once to carrier.
2. Check the contents list. Contact distributor for
missing items.
Contents:
4--6V Batteries -- Optional
S
1--Battery Charger -- Optional
S
1--Battery Plate (#100707)
S
3--Battery Cables (#130367)
S
1--FaST--PAK Concentrate (FaST Model)
S
1--Squeegee Assembly
S
Pad drivers, brushes and pads must be purchased
separately.
3. To uncrate your machine, remove the shipping
hardware and straps that secure the machine to
the pallet. With assistance, carefully lift the
machine off the pallet.
ATTENTION: Do not roll machine off pallet unless
a ramp is used, machine damage may occur.
ATTENTION: To prevent possible machine
damage, install batteries after removing machine
from shipping pallet.

INSTALLING BATTERIES

WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Hood Open When
Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
Battery Specifications:
Four 6 volt, deep cycle, 305 amp hour batteries. Part
Number #606991. Maximum battery dimensions are
178mm (7 in.) W x 308mm (12.13 in.) L x 356mm
(14 in.) H.
1. Turn all switches to the off position and pull out the
main (10 amp) circuit breaker button as shown
(Figure 1).
Speed Scrub 2701/3301 (07- -04)
Home Find... Go To..
ATTENTION: To prevent motors from accidental
starting, be certain to pull out the main circuit
breaker button before installing batteries.
2. Carefully hinge open recovery tank to access
battery compartment. Remove loose battery
cables from compartment (Figure 2).
3. Carefully install batteries into compartment and
arrange battery posts as shown (Figure 3).
ATTENTION: Do not drop the batteries into the
compartment, battery and machine housing
damage may result.
FRONT
4. Before connecting the battery cables, make sure
the terminals and posts are clean. Use a post
cleaner and wire brush if necessary.
OPERATION
FaST Model
FIG. 1
FIG. 2
FIG. 3
7