Operating Fast Scrub System (Fast Model) - Nobles Speed Scrub 2701 Opérateur Manuel Et Liste Des Piéces

OPERATION
NOTE: To increase or decrease the maximum solution
flow, turn solution flow adjustment knob (for
conventional scrubbing only). Turn knob clockwise to
decrease solution flow or counterclockwise to increase
(Figure 20).
6. Slowly rotate control grips forward to begin
scrubbing. The machine will continue to gain
speed the further you rotate grips. To drive
machine in reverse, simply rotate control grips
backwards.
ATTENTION: Always start machine out slowly to
prevent machine from leaping forward.
7. View amount of solution flow on floor and adjust
solution control lever to desired solution flow (for
conventional scrubbing only).
8. To stop machine, release control grips.
OPERATING FaST SCRUB SYSTEM (FaST
MODEL)
How the FaST System operates (Foam Scrubbing
Technology): The FaST--PAK concentrate agent is
injected into the system with a mixture of a small
amount water and compressed air. This mixture
creates a large volume of expanded wet foam. The
expanded foam mixture is then dispersed onto the
floor while two scrubbing disks go to work. By the time
the squeegee picks up the mixture, the patented
foaming agent has collapsed and recovered into the
recovery tank. By performing the FaST system
application, you can increase your productivity rate by
30% by reducing your dump/fill cycle. You will also
reduce your chemical usage and storage space. One
FaST--PAK of concentrated agent allows you to scrub
up to 1 million sq. ft.
1. Make sure that the FaST--PAK carton is properly
installed (See INSTALLING FaST--PAK
AGENT).
12
FIG. 20
Home Find... Go To..
2. Make sure that the solution tank is filled with clear
cool water only. DO NOT add conventional
cleaning agents in solution tank. Conventional
cleaning agents/restorers in the solution tank may
result in premature FaST system failure.
3. Make sure that the main and brush switches are in
the on position, and pull the solution flow lever all
the way back (Figure 21).
FIG. 21
NOTE: The water flow rate from the solution tank is
automatically regulated by the operation of the FaST
system. The solution flow rate can not be adjusted by
the Solution Control Adjustment Lever during the
FaST Scrub mode.
4. Press the FaST Scrub/Conventional Scrub Switch
toward the FaST Scrub mode position -- switch
light will come on (Figure 22).
NOTE: The solution flow lever must be in the pulled
back position in order to activate the switch.
FIG. 22
NOTE: To scrub with clear water only, simply press
the FaST Scrub/Conventional Scrub Switch toward the
Conventional Scrub mode position. This allows you to
operate the machine in a rinsing application.
5. Follow the standard MACHINE OPERATION
instructions to begin scrubbing.
Speed Scrub 2701/3301 (07- -04)