Using The Timer; Automatic Cut-Out; Countdown Timer - AEG 68031 K-MN Notice D'utilisation

10
Operating the appliance
3
If the power function has ended, the cooking zones automatically switch back to the
heat setting set previously.
Power Management
The cooking zones of the cooking surface have
a maximum power.
The maximum power is reached when the heat
setting 14 has been set for all cooking zones.
Two cooking zones generate a pair (see figure)
and therefore, the power management shares
the maximum available power between these
cooking zones.
When the power function is selected for one
cooking zone, the power management makes
the additional power for this cooking zone
available by reducing the power of the other
cooking zone.
Example: the heat setting 14 is selected on one
cooking zone. The power function is switched
on for the corresponding cooking zone. The po-
wer function is carried out but the heat setting
14 of one of the cooking zones and the power
function for the other cooking zone of the pair
exceed the maximum power for both at the same time. For this purpose, the power ma-
nagement reduces the power of the cooking zone that switched on first from 14 to ex-
ample 5 and the display of this cooking zone changes between 14 and 5 and then stays
at the current possible maximum 5. (If the display changes between 14 and 5 or 14 and
3 or another value depends on the type of appliance and the size of the cooking zone.).

Using the timer

Function

Automatic cut-out

Countdown timer

3
If just one countdown value is set you can change it only when the appliance is swit-
ched on.
3
If a heat setting is set on this cooking zone in addition to a countdown timer, the
cooking zone is switched off after the time set has elapsed.
All manuals and user guides at all-guides.com
Condition
a heat setting is set
cooking zones not in use
Outcome after the time
has elapsed
acoustic signal
00 flashes
Cooking zone switches
off
acoustic signal
flashes
00