Cleaning And Maintenance - Silverline RS5336C01 Manuel D'utilisation

• Do not leave your hob operate on its own, check frequently.
• Turn off the supply tap when you do not use your hob.
• Contact your authorized service in case you need any technical intervention.
• Do not place your pot as to cover the control buttons partially.
• You can use match to ignite the hob in power failures.
• Do not leave the hob while it is in operation and keep children away from
the hob. Make sure that the hob handles are correctly positioned and in the
oilcontaining cookings, be careful considering that the oil can flare in case of
any boil over.
• Keep the explosive (spray) products away from the hob which is in operation.
• If your hob has a cover, the food spilled on the cover must be cleaned before
opening the cover. If you have a glass cover, starting the hob while the cover
is closed may cause the explosion of the glass due to the heat. Make sure the
hob is not in operation before closing the cover.
• This apparatus is not allowed to be used by the people of poor physical and
mental capacity (including children) or until trained or kept under supervision
by the responsible adults in terms of their safety, and by the people who do
not have experience on the use of electrical apparatus. In order to prevent
children playing with the apparatus, they must be kept under control.
• It is not recommended to use pots lying beyond the edges of the plate.
WARNING: BEFORE ANY CLEANING OR MAINTENANCE, PULL THE PLUG OF THE
HOB AND TURN OF THE GAS CONNECTION AND LET THE DEVICE COOL DOWN.
HOB BODY
Clean the electrical zone, enamelled steel pot support, heating zone cover ''C''
and heads ''T'' with warm soapy water periodically (see figure 6). Clean the
ignition devices ''AC'' and thermocouple sensors ''TC''. They should not be put
in the dishwasher. As a result of this process, all parts should be rinsed and
dried. Do not clean the parts when they are hot and do not use abrasive cleaning
products. Do not keep vinegar, coffee, milk, salted water, lemon or tomato juice
for a long time on the enamel surfaces.
WARNINGS:
• Please note the following points before replacing the parts:
• Make sure that the "T" (see figure 6) openings in the burner heads are not

CLEANING AND MAINTENANCE

GB
41