Electrical Connection - Silverline RS5336C01 Manuel D'utilisation

NOTICE: The device must be assembled in accordance with the company's
instructions. The manufacturer is not responsible for the damage on people,
animals or objects caused by faulty installation. The electrical connection should
be done in accordance with the standards in force and the provisions of law.
• Prior to connecting, make sure the socket or plant is equipped with an effective
ground connection in accordance with the standards in force and provisions
of law. In the event of these rules not being obeyed, the manufacturer is
exempted of all responsibility.
• The voltage must correspond with the values displayed on the data plate, and
the wires of the electrical system should have enough capacity to carry the
load again displayed on the data plate. When the connection to the supply
mains is made through a socket:
• In case of the socket not being equipped, implement a normalized plug onto
the supply cable "C" (see figure 11) appropriate for the load specified on
the data label. Connect the cables in accordance to the scheme on figure 11
minding the counterparts given.
Letter L (phase) = small brown cable; Letter N (neutral) = small blue cable;
Ground symbol = small green-yellow cable
• The supply cable must be positioned so that it will at no point reach the
overtemperature of 75K.
• Do not use reductions, adapters or derivatives for connection: these may
cause contact malfunctions and dangerous overheating.
• The socket must be accessable once the embedding is completed.
• For when the connection is made directly to the grid circuit.
• Place an omnipolar key between the device and grid sized according to the
load of the device in accordance with the installation rules in force.
• Make sure that the ground cable is not interrupted by the key.
• For improved safety, the electrical connection may be preserved by a
differential key with high precision.
• It is especially recommended that you connect the green-yellow ground cable
to an effective ground facility. Prior to any procedure regarding the electrical
components of the device, the power connection must be cut off.
In case of necessity of alterations in the electrical system of your home or the
socket being unsuitable for the device's plug, these procedures must be carried
out by a authorized and licensed person. This person must make sure the wire
crossings are appropriate for the power consumed by the device.

ELECTRICAL CONNECTION

GB
35