Silverline RS5336C01 Manuel D'utilisation page 37

GB
Figure 12. Figure 12/A
CHANGING THE NOZZLES
The hobs may be converted to the preferred gas type by changing the nozzles. In
order to do this, remove the lids on the heating zone and use a key "B" to remove
the nozzle from "A" (FIGURE 13) and mount the nozzle of your preference.
Tighten the nozzle. Adjustments must be made as stated above after the nozzle
change. You can find the hob heat input values, nozzle sizes and gas pressures
on the tableau below.
The conversion kit may be included in the package of your device as well as be
supplied from technical services.
Figure13.
37