Arneg Ankara 4P Manuel D'installation Et De Service page 41

Conditions For the cabinet to work properly, the room temperature and relative humidity
must not exceed the limits of climate class 3 (+25°C; R.H. 60%) according to the
environmental
standard EN-ISO 23953 - 2.
Receiving the • ensure the packing is intact and that it does not display readily apparent dam-
cabinet
• perform the unpacking operation carefully in order not to damage the cabinet
• check that the cabinet components are intact
• should you notice any damage immediately inform the manufacturer
Installation
procedure
(Fig.4)
What to avoid
CAUTION! Discarded packing parts. Injury.
DO NOT leave packing parts (nails, wood, staples, etc.) and tools used for the operation
(pliers, scissors, etc.) in the working area.
These objects must be removed with appropriate means and taken to their respective col-
lection places.
i
For correct disposal, the package consists of:
wood - polystyrene - polythene - PVC - cardboard.
05060215 00 05-2022
age
Carefully examine the installation area, eliminating any danger to the op-
erator
remove the package only if the cabinet is placed in the area of use.
Step
1 lift the cabinet safely
2 use suitable scissors to cut the clip tightening straps-A-
3 remove the clips and the frame
4 lower and place the cabinet in the area of use
7 adjust the horizontal position of the cabinet using a spirit level (Fig.9)
8 check that all feet are into contact with the floor
9 level the cabinet both at the front and at the back
gently remove the protective film, eliminate glue residues with suitable
10
solvents
11 carry out the first cleaning using neutral products and a soft cloth.
- Install maximum 3 cabinets within the same power supply and cooling
line
- If the cabinet is moved, repeat the levelling check - incorrect levelling
will impair the function of the cabinet
• DO NOT use alcohol to clean the methacrylate (Plexiglass) parts
• DO NOT use abrasives or metal sponges
• DO NOT install the cabinet (Fig.8):
- in areas at risk of explosion
- in open air and therefore exposed to the elements
- near heat sources (direct sunlight, heating systems, incandescence
lamps, etc.)
- in the vicinity of air currents (close to doors, windows, air-condition-
ing systems, etc.) that exceed a speed of 0.2 m/s
• Dragging. Failure/deformations/tears
DO NOT drag/push the cabinet
Follow the instructions for safe handling
Ankara 4P - Arka 4P
Action
English
41