HumanTechnik signolux A-2617-0 Mode D'emploi page 13

Status-LED
The receiver informs about the state of its
own batteries as well as the batteries of the
linked transmitters:
- A sufficient battery charge level of the
receiver is indicated by the status LED
flashing every 5 to 6 seconds in red.
- A low battery level of the receiver is in-
dicated by the status LED flashing every
two seconds in red.
Please recharge the receiver as soon as
possible (attach it to the power supply unit).
- If the battery level of a transmitter is low,
the status LED lights up red every 2 se-
conds after the transmitter has transmit-
ted its signal. Please replace the batteries
of the according transmitter at the next
possible opportunity.
Behaviour of the status LED when
the power supply unit is connected:
Charging the battery: The status indicator
lights up red. The red light is interrupted for
half a second every 6 seconds.
Battery is charged and the unit is ready
for operation: The status indicator lights up
green. Every 6 seconds, the status indicator
briefly lights up in red.
Recalling the last alert, cancelling the
current alert
Press the »●« button to display the last reg-
istered alert again.
You can also cancel an active indicated alert
by pressing this button.
AUX-socket and power connector
The »AUX«-socket (8) and the connector for
the power supply (10) can be found on the
rear of the receiver.
All Humantechnik modules can be connec-
ted to the AUX-output (vibrating pad, flash
module, vibrating contraption etc, available
as accessories). An indicated event will be
forwarded to the connected modules which
will then react accordingly.
The power connector is used to power the
receiver via the power supply unit. This is
used to recharge the batteries, but it can
remain connected for continuous operation
of the receiver.
English 13