Fittings / Technical Data / Safety Instructions
Technical Data
Minimum flow pressure
Operating pressure
Recommended operating pressure
Test pressure
Hot water temperature
Temperature scale
Safety stop
Flow capacity at 3 bar
Hand shower (1)
Body showers, 6 jets (2)
Overhead shower (3)
Overhead shower + body showers
Hand + body showers (4)
Hand + Overhead shower
22
Overhead shower
Halogen spotlight
Canopy
Aluminium
profile
Glass tray
Body showers
IV lite control
Thermostat grip
Mistral hand shower
Hand shower holder
1.5 bar
max. 10 bar
2 – 5 bar
16 bar
max. 70°C
20 – 60°C
14,5 l/min
21,7 l/min
13,9 l/min
26,3 l/min
27 l/min
22,7 l/min
Flow heater:
Applicable for flow heaters at min. 24 kW and 2 bar
flow pressure before the Shower panel. Only one
consumer possible, not two simul-taneously. Do not use
the function Hydro-massage (cascade).
Pressure differences:
The pressures of the cold and hot water connections must
be balanced.
Safety
instructions
Prestige Sensotronic with lighting:
You only require a socket for the electrical installation of
the Shower panel. An external transformer is supplied to
operate the lighting.
Electrical socket installation must only be performed by a
qualified electrician. The complete power supply runs via
a 230 V/50 Hz AC connection and must be protected
by a 2-pole residual current operated circuit breaker with
30 mA fault current.
The relevant national regulations in the applicable
version must be observed during electrical installation.
Installation and in spection tasks must be performed by
authorized electricians. All work on the Shower Paneel
must be performed with the power disconnected.
The external transformer performance is 50 VA. A wiring
conduit with a inside diameter of at least 25 mm must be
provided to install the power supply cable. The
transformer must be installed in the dry area (protection
zone 3). The cable provided allows the transformer to be
installed max. approx. 7 m from the Shower Paneel. The
transformer must be accessible at all times. A damaged
connection
cable
transformer must not be operated in this case.
38°C
From • the function is guaranteed.
for
connecting
cannot
be
replaced,
the
DP
and
the