Water Supply; Operation; Before Starting The Machine - GÖLZ FS125 Mode D'emploi Et Liste Des Pièces De Rechange

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FS125
3.4

Water supply

Important: The operation is to be
carried out in wet cutting, in order to
prevent the occurrence of harmful
particulate matter and to increase the
lifetime of the cutting tool.
Attention:
designed for wet cutting technique,
must never be used without water
supply! Always make sure that there is
enough water supply!
The supply of water at the cut ensures that the tool is
cooled, the dust of the material is bound and the cut is
rinsed out.
Attention: Use only water for cutting
which is free from coarse impurities!
Do not use salt water!
Danger: Do not use the attached water
tank when cutting with wet cutting
diamond blades. The segments may
crack off and cause injuries to the
operator or bystanders!
1
Cutting with wet-cutting blades:
Connect the detachable water hose with an external
water supply. Check the ball valve (2) is closed (ball
valve lever in 90°-position to the water flow).
For cutting open the ball valve (2) (ball valve lever in
the water flow position).
Cutting with dry-cutting blades:
Fill the water tank with clean water. Check the ball
valve (1) is closed (ball valve lever in 90°-position to
the water flow).
For cutting open the ball valve (1) (ball valve lever in
the water flow position).
Tools
which
are
2
4.

Operation

only
Information: Unconditional observe
the owner's manual of the engine
manufacturer!
Danger: Never touch rotating parts
like
operating!
4.1

Before starting the machine

Check the machine for safe operating condition.
 All components must be properly mounted.
 The functions of the combustion engine must
function properly.
 Do not make any changes on operating
elements and safety devices.
The machine may only be operated in safe operating
condition.
Lock the push bars so that the machine can be
operated in a favorable posture.
If work is carried out where harmful or explosive
substances, such as dust, sludge occur, observe the
applicable national regulations.
If there is a risk that, during the cutting process,
material particles are accelerated outwards, wear
safety goggles.
Danger: Demolition parts can cause
injuries to the operator while cutting!
When travelling on public roads, ways and places
always observe the valid traffic regulations and, if
necessary, make sure beforehand that the machine is
in a condition compatible with these regulations.
After
operating
unintentional moving.
Danger: The sound pressure may
exceed 85 dB(A)!
Appropriate to the application of the machine it could
be necessary to wear further protective equipment.
- 30-
blade
shaft
or
blade
secure
the
machine
BA-DE-GB-FR-NL (001)
®
while
against
5009002-00

Publicité

Table des Matières
loading

Table des Matières